Call us, message us on WhatsApp, or request your quote online — we'll respond in under 10 minutes during business hours. Not for single pictures. Yes for heavy mounts or large compositions to confirm feasibility and provide a fixed price. Call us, message us on WhatsApp, or request your quote online — we'll respond in under 10 minutes during business hours.

Improperly installed articulated mounts are the leading cause of TVs falling in homes. The articulating arm multiplies the leverage effect when the TV tilts or swivels. If the wall fixing is marginal, the actual weight exerted on the fastener can triple at full extension. That's why we always look for metal studs behind plasterboard or concrete pillars. We never anchor an articulating arm solely to plasterboard or hollow brick. For complete IKEA, Leroy Merlin, or custom-built kitchens, the typical process involves several steps. An initial visit to measure and check the wall. Walls are never perfectly straight, and sometimes pieces need adjusting to reality. Module assembly in the workshop when possible, to save time. On-site installation with secure anchoring and levelling. Appliance connection, coordinated with the electrician and plumber if needed. Fine adjustment of doors and drawers. And installation of plinths and finishing trims. The second risk is wall damage. Anchoring a wall cabinet without the correct wall plugs for the material can tear out plaster or brick when someone pulls on a drawer. For every material (concrete, brick, plasterboard, tile) there are specific wall plugs. Using the same generic plug for everything is a recipe for the cabinet falling down weeks later.

The first mistake is using a standard wall drill bit on tiles. The tip slips, and the tile cracks. You need a ceramic drill bit with a diamond tip. The second mistake is using the hammer function on tiles. The vibrations crack the tile from within, leading to fine cracks appearing weeks later. You must drill without percussion. The third mistake is not marking the centre accurately. A pencil mark on masking tape around the spot prevents the drill bit from slipping. For small pictures up to 2 kilos, a hook or nail is sufficient on most walls except tiles and plasterboard. For medium pictures from 2 to 8 kilos, use specific wall plugs for the material with 4-5 mm screws. For large pictures and mirrors up to 15 kilos, use reinforced plugs and 6 mm screws. For LCD TV mounts up to 50 inches and a real weight of up to 25 kilos (including the mount's weight), use two anchoring points to a stud or pillar with 8 mm screws. Plasterboard (laminated gypsum board) is a modern material used in ceilings and partitions in recent constructions. It's very fragile without the correct wall plugs. For light loads up to 5 kilos, toggle anchors are sufficient. For medium loads, there are metal toggle bolts (like Molly bolts) that expand behind the board. For heavy loads like large TVs, you need to locate the supporting metal studs behind the plasterboard with a detector and screw into the stud.

The price for door adjustments in La Palma de Cervelló typically ranges between €27 and €224 as an approximate guide. The final figure depends on the property's condition, materials, and work time, and we always finalise it after seeing photos or—if you prefer—after a free site visit. Approximately 60-90 minutes, including preparation, marking, drilling, fixing, and cleaning. We provide a fixed cost for the job. If the fixing fails, we'll return to reinforce it at no extra cost. Plugs are calculated with a safety margin.