Call us, WhatsApp us, or request your quote online — we'll respond in under 10 minutes during business hours. Leak detection and repair, parts replacement, or gas recharge as diagnosed. The electrical inspection includes nominal compressor consumption at start-up and during operation, wiring insulation checks, condition of start-up capacitors (which degrade after the seventh or eighth year), and thermostat verification. The final disinfection with certified HVAC products eliminates bacteria, fungi, and odours accumulated in the coil. This prevents the characteristic damp smell when you start the air conditioning after winter.

Fault location with certified instruments before proposing a repair. When an air conditioner stops cooling as it used to, there are several possible causes that might seem similar at first glance. The difference lies in the speed and nature of the failure. If the air conditioner has gradually lost efficiency over months, it's most likely a slow gas leak that has reduced the amount available in the circuit, making it work poorly. If the air conditioner was cooling normally and suddenly stops cooling from one day to the next, it's usually a large leak, compressor failure, or an issue with the electronic board. If it starts but stops after a few minutes with an error message on the remote, it could be the thermostat, a temperature sensor, or a communication problem between units. Professional diagnosis when the air conditioner isn't cooling as before. Gas leaks, compressor, electronics, and sensors. Repair or replacement as appropriate.

Common components (remotes, capacitors, sensors) yes. Electronic boards and compressors are ordered and arrive in 2-7 days depending on brand and model. Mitsubishi, Daikin, LG, Toshiba, Samsung, Panasonic, Fujitsu, Hitachi, Hisense, and others. For official warranty issues, we refer to the brand's authorised service centre. We arrive with a complete set of instruments. Pressure gauges, contact and infrared thermometers, electronic gas leak detector, multimeter and clamp meter for electrical measurements. We also bring the specific diagnostic application for each brand to read error codes stored on the board.

The price for a new installation in Progrés typically ranges from 44 to 588 euros. The final figure depends on the property's condition, materials, and labour time. We always provide a fixed quote before starting work. Older non-inverter models start and stop abruptly at maximum power, which puts more stress on the compressor. Modern inverter models modulate smoothly and last longer. Their electronics are more sensitive, and after the seventh or eighth year, board failures may start to appear, requiring the entire module to be replaced. The decision to repair or replace the unit depends on the cost of the part versus the price of an equivalent new unit. Call us, message us on WhatsApp, or request your quote online — we'll respond in under 10 minutes during business hours.