Call us, message us on WhatsApp, or request a quote online — we'll reply in under 10 minutes during business hours. Without measuring the copper piping, checking the facade, and evaluating the electrical panel, we cannot provide an honest quote. The visit is free and without obligation. The first step is always the preliminary visit. We measure the exact length of copper piping between the indoor and outdoor units and check the available space for the outdoor unit and its orientation. We also assess if the electrical panel has sufficient capacity for the new unit's consumption or if the contracted power needs to be increased, and we verify community regulations regarding facade installations.

After connecting the copper pipes between the indoor and outdoor units, a deep vacuum must be pulled on the refrigeration circuit to remove air and moisture before charging the gas. Without a vacuum, residual air mixed with the refrigerant reduces the unit's efficiency by 20-30 percent, overheats the compressor, and drastically shortens its lifespan. The correct vacuum is achieved with a specific pump that lowers the pressure to -700 millibars and is held for 30 minutes to verify its tightness. The diagnosis begins with a brief interview with the client about when the problem started, how it manifests, and if anything unusual happened beforehand (storm, unit moved, impact). It continues with a visual inspection for oil stains indicating leaks, visible mechanical damage, or accumulated dirt. Then, electrical measurements and refrigeration analysis with gauges are performed. Once the cause is identified, a fixed quote for the repair is provided, compared against the cost of a new unit if the damage is extensive. Indoor fan blocked by accumulated dirt or worn bearings. When the fan doesn't spin at the correct speed, air doesn't circulate properly over the coil, and the cooling sensation in the room is significantly reduced even though the unit is running.

Yes, it's mandatory in Spain for any handling of refrigerant gas. Without it, the manufacturer's warranty is void, and the installation may be declared illegal. Toshiba, Panasonic, and Fujitsu are a notch below in price but not significantly in quality. They are a good option for tighter budgets. More economical brands like Samsung, Hisense, or basic Hitachi models work correctly for the first four or five years, but their efficiency and durability are lower, and they usually require more maintenance. The second detail is the gas charge. The quantity must be exactly as specified by the manufacturer for the installed copper length. You won't notice a gram more or less immediately, but over 5 years, it translates into performance loss. The charge is always done with a precision electronic scale, not estimated by pressure as some quick installers do.

The price for gas recharging in La Palma de Cervelló typically ranges from €126 to €1602 as a guideline. The final figure depends on the property's condition, materials, and labour time, and we always finalise it after seeing photos or —if you prefer— conducting an on-site inspection, without obligation. As a general rule, if the repair cost exceeds 60 percent of the price of an equivalent new unit, it's not cost-effective. This is because repairing an expensive component doesn't change the age of the rest of the unit. Other components will likely start failing soon. Replacing the compressor on a nine-year-old unit for a significant amount, knowing the electronics and fans are also aging, is generally a poor investment. Burned-out compressor in budget-range units with 6-9 years of intensive use. This is the most expensive fault. Replacing the compressor costs a considerable portion of a new unit's price and is only worthwhile for premium units with reasonable residual lifespan. For basic units, we usually recommend replacement.